PLINK INJECTOR (12V-24V) ENTTEC

The PLink Injector has been engineered to work as part of an ENTTEC Pixelator series setup to make it fast, easy and affordable for you to control LED pixel tape or pixel dots over long distances.

Choose from the 5V or 12-24V options depending upon your layout, simply re-inject power from an external source, and you’re away!

Also available in a rugged IP66-rated version for extreme weather conditions and outdoor installations.

Specification:

Input Voltage: 12V - 24V DC

Maximum Throughput Capacity:

12 V - 120 W

24 V - 240 W

Maximum Power Consumption: 3.5W

Data Input Protocol: PLINK

Data Output Protocol: Refer to the Pixelator/Pixelator Mini/ Din Pixelator Mini this device is connected to.

https://www.enttec.com/support/supported-led-pixel-protocols

Data Output Capability Per PLink Port: 340 RGB Pixels

Operating Temperature: -10° to 65° C

Ingress Protection Rating:

IP20

IP66 

What is theENTTEC PLink (Pixel Link) system?

ENTTEC’s PLink protocol has been especially designed to extend your LED pixel or Constant Voltage layout over long distances.

With their compact installation footprint, you can use a series of PLink Injectors to convert PLink data from your Pixelator, Pixelator Mini or Pixelator Mini PX1-8D allowing you to easily control LED pixel tape or pixel dots up to 300 metres away over standard CAT 6 cable.

Alternatively, use ENTTEC’s CVC4 to control Constant Voltage (CV) LED tape using the same method!