MODUS ADL-01 ARTNET 2CH SPI LED

MODUS ADL-01 ARTNET 2CH SPI LED Digital Strip is a driver for digital LEDs with ArtNet protocol support.

It is powered from safe voltage in the range of 12-24VDC. Has an external power input or can be powered via Passive POE.

It is ideal for controlling digital LED strips and digital LED modules in a permanent installation.

The device has 2 independent outputs with the possibility of connecting up to 170 RGB pixels on each of the outputs.

Thanks to the flat housing, we can mount the controller near controlled LEDs.

The system of standard RJ45 connectors for Ethernet and detachable screw connectors for power input and LED output facilitates assembly and subsequent operation.

The device uses protection against reverse polarity of the supply voltage and against overload.

They protect not only the converter but also the controlled LEDs against damage.

The converter works in a LAN and is controlled by the popular ArtNet protocol. Works with dedicated MODUS DevManager software, so all configuration is done remotely via Ethernet. It is ideal if the device is installed in hard-to-reach places.

The module has Data and CLK signal outputs, works with digital LEDs powered from 5V, 12V and 24V.

Supports 6 types of digital LEDs: APA101, APA104, TM1803, TM1804, TM1809, TM1812

Technical specifications:

Outputs: 2 x 170 RGB pixels for digital LED modules (DATA and CLK signal)

Control: RJ45 connector (Ethernet, ArtNet)

Power supply: 12-24V DC, 200mA - Passive PoE or power connector

Dimensions: 67x68x25 mm (without connectors), 67x86x25 (with connectors)

Supported systems: APA101, APA104, TM1803, TM1804, TM1809, TM1812

Configuration is by easy to use DevManager software

The manufacturer reserves the right to make changes in the operation and use of the device, aimed at improving the product without notice.